black jack aluminum roof coating reviews

Yes, the granules reflect most of it, but in terms of area, there's probably some good percentage of area still exposed that doesn't have granule. Reflective coatings would work here in all the little cracks and crazes you can't even see UV still gets in there and breaks down the material. Yes, I know the naysayers, give them some props, but my experience tells me UV inhibiting coatings work, and common sense says silver reflective coatings have to be better than black.

I can imagine reflective coatings helping a lot they work. I'd put that in the basic half-assed install with the usual inadequacies. All feedback and suggestions much appreciated. Unfortunately, there are few reviews on those products. Another more expensive option is Hydro-stop or Soy Expandothane. Yet, a lot of people on forums have suggested using a good asphalt/rubber aluminum coating (such as Karnak) to prolong roof life. I don't want to sink money into coatings that may not extend the life of the roof. I have been searching through many sites and posts to try and make a sound decision. The also said don't bother coating it as is has the embedded granules and those help reflect heat. However, the local ABC roofing supply company has advised me that alligatoring is a sign of the roofs near end and suggested that I can three course it with mesh and cement topped with granules to hopefully get more life out of it. Also mention that water less than a 1/2' deep isn't much of a concern as well. Reading through some of the post here concerning flat roofs there is mention that alligatoring isn't necessarily an issue as long as there are no flaps and it isn't through the base ply. Also there is an area of ponding that is less than a 1/2' deep. The roof looks to be in good shape other than alligatoring at the peak and a few other small areas, and a few areas where the cap sheet is lifting up from the drip edge. The roof has minor water curling issues in the corners (2 foot extended eves), but no leaks within the home. The roof is 9 years old low slope that was initially installed using mechanically fastened single ply base sheet with hot-mopped adhered granulated SBS mod-bit cap sheet. My home is in the Tampa Bay area of Florida.

I have a few questions I hope to get answers to. I have read through several roofing post and answers and I am very impressed with knowledgeable members here. My name is Mike, first time posting here, not an inspector.

Black jack aluminum roof coating reviews